1. Replacing Rear Center High Mounted Stop Light (CHMSL)

Tools Required:
1. 10mm socket/wrench.
2. 15mm torx-bit with driver.

Step 1: Remove the inboard two tails (1 on either side of the CHMSL) with the torx driver (1 screw holds each light to the fascia)

Step 2: Remove 10mm nuts (4 - total) that secure the CHMSL to the fascia. You can access 2 nuts from each opening on either side of the CHMSL.

Step 3: Unplug the electrical connector from the CHMSL (lift up on the tab and unseat the connector) prior to lifting the CHMSL off of the fascia.

(If required, slot the net hole 2mm rearward in car position)

Step 4: Gently lift the CHMSL off of the fascia.

Step 5: Install the "Brite Ideas" CHMSL and follow steps 3 through 1.